3Com 3036, Configuration Manual

Page: 218 / 762

214 C
HAPTER
16: C
ONFIGURING
LAPB
AND
X.25
Figure 64 X.25 switching networking diagram
1 Enable or disable X.25 switching
In the system view, perform the following task to enable or disable X.25 switching.
Table 257 Enable or disable X.25 switching
Add or delete a PVC route
Table 258 Add or delete a PVC route
After configuration, the
display x25 switch-vc-table pvc
command can be
used to show the virtual circuit route table.
2 Add/Delete an SVC route
In the system view, the commands in the following table can be used to add or
delete an SVC route.
Table 259 Add or delete an SVC route
After the configuration, use
display x25 switch-vc-table svc
command to
display the switching route table.
Configure X.25 Load
Balancing
Introduction to X.25 Load Balancing
Using the property of hunt group of X.25 protocol, ISPs can provide load
balancing function in X.25 packet switching networks. X.25 load balancing can
implement the load balancing in different DTEs or different links of a single DTE,
PC
PC
Quidway Router
X.25 host
X.25 host
Operation Command
Enable X.25 switching
x25 switching
Disable X.25 switching
undo x25 switching
Operation Command
Add a PVC route
x25 switch pvc numbe r interface
serial port-number pvc number
Delete a PVC route
undo x25 switch pvc number
Operation Command
Add an SVC route
x25 switch svc x.121-address [ sub-dest
destination-address ] [ sub-source source-address
] interface serial interface-number
Delete an SVC route
undo x25 switch svc x.121-address [ sub-dest
destination-address ] [ sub-source source-address
] [ interface serial interface-number ]