125 / 128
Identification: MD-AL-GI-00
Rev. 1.0 of 21/07/2021 - Application: GID
User’s Manual 1PH 3000TLM-6000TLM-V3
Rev. 1.0 21/07/2021
Enter the serial number (S/N) of the datalogger and click “Check RMS”. If the datalogger has been configured
correctly, a screen will open where you can enter the required information relating to the field to be
installed.
Once the “location” of the field has been entered, click “Calculate Location Information” to allow the system
to obtain the latitude, longitude and time zone of the installation. Click “Confirm” to complete the
configuration of the field. You only need to wait a few minutes to view the data flow on the ZCS Azzurro
portal.
ATTENTION: The location data is essential for the correct operation of the datalogger in the ZCS
system. It is important to define it very carefully.
10.4.8.2.
Network configuration
At the time of purchase, the Datalogger is configured in DHCP, i.e. dynamic configuration.
However, if you want to set up a static configuration for your Datalogger, you can access the internet page
via the link RMSxxxxxxxx: 8888, as shown in the figure (e.g. RMS00000007).
