InZennio Z41
http://www.zennio.com
Tecnical Support:
http://support.zennio.com
53
Through the
Scene
parameter it is possible to assign each of the two buttons
(left / right) the number of the scene to be sent (1 – 64). In addition,
Action
(which permits the options “Run” and “Run and save”) lets the integrator set
whether the device will only send execution orders for the specified scene (after
a short press), or it will possible, apart from sending execution orders on short
presses, to also send save orders for such scene, in the case of performing a
long press on the button
Last, the dropdown list under
Button Icon
sets the icon to be displayed by the
buttons.
Note
:
a list with all the icons available in Z41 can be found in document “Z41
Icon list”, available at www.zennio.com
.
g) Shutter Control
Shutter controls permit sending move up, move down, stop or step shutter
orders to the KNX bus by pressing the buttons in the box. In addition, the box
will contain an indicator that will permanently show, as a percentage, the value
of the status object.
Figure 50
Shutter Control
The only specific parameter for this function is:
Action
: sets which of the two buttons will send the move up orders and
which the move down orders. Options are “Left Down, Right Up” (default)
and “Left Up, Right Down”.
Setting up a box as a shutter control enables three communication objects,
[Pn][Bi] Shutter Position
(1 byte),
[Pn][Bi] Move Shutter
and
[Pn][Bi] Stop
Shutter
(both, binary objects). The former acts as the status object, which
determines the value shown in the box; it will be necessary to link it to the
analogous object from the shutter actuator (as it does not get automatically
