ZENEC Z-E3776, Руководство по эксплуатации

Страница: 15 / 88

15 Rev.A
Example of reassignment:
a. In the first step, the required function must be selected, in this case Camera (CAM). Tap on the
[CAM] function symbol in the middle of the function symbol field, which has a light blue border.
b. Press the relevant LFB button on the rear of the steering wheel (top left in this example). The
system sets the camera (CAM) function to the top left LFB button and also in the virtual LFB
display on your ZENEC. The camera source can be called up later by pressing the top left LFB
button instead of the default setting “Skip forwards” [>>I].
c. Continue reassigning the remaining LFB buttons. Once all buttons on the LFB have been
assigned, the LFB assignment can be completed. The reassignment is saved automatically,
and the new configuration can be used from now on. In order to restore the defaults, tap on
the “Factory setting” button. The button functions are then reset to the default values and
assignments.
NOTE: The front telephone and voice buttons are only connected via a LIN Bus adapter cable
or an optionally available CAN-IR Stalk interface “N-XFDUC8-SWC1”, and cannot be changed.
Whereas the rear buttons can be connected to the ZENEC via an analogue LFB cable.
NOTE: The LFB buttons for driving, on-board computer and cruise control operation are direct-
ly assigned to the respective vehicle functions, i.e. the function of these buttons on the steering
wheel is completely independent of the device installed in the vehicle.
NOTE: A correct function can only take place if the LFB connection is set to Mode 2. [Settings]
➔
[Various]
➔
[LFB Assignment]
➔
“Mode 2”.
NOTE: Fault-free operation of the steering wheel remote control can only be guaranteed if
you use the original ZENEC accessories included in the scope of delivery. The ZENEC system
and the original accessories must never be modified or altered in any way. Incorrect handling can
damage the vehicle and the ZENEC system.