CoolSculpting® Elite
System User Manual
Cleaning and Maintenance
CS-UM-CM3-02-EN-D
47
►
To clean the touch screen:
1. Dampen a soft lint-free cloth with isopropyl alcohol or window cleaning fluid.
2. Wipe the touch screen gently.
Cleaning the Bucket
Approved cleaning products include:
•
Damp towel or water-based wipe
•
Isopropyl alcohol
•
Mild detergent and warm water
•
PDI Sani Cloth Plus wipes
►
To clean the bucket:
1. Dampen a towel with a cleaning solution or use a water-based or cleaning solution wipe, wipe
away residual gel.
2. Or, pull out bucket to rinse with water. Dry the bucket with a cloth and return to its slot.
Maintenance
Filter Replacement
The purpose of this filter is to extend the service life of your control unit. It is recommended to replace
the filter every 6 months.
To replace to the filter:
1. Access the filter door from the front of the console, located below
the base.
2. Push the filter door to release the “push-push” latch.
3. Rotate the door down to access the filter attached.
4. Pull filter free from door.
5. Install new filter so that the plastic hooks on the door hold it in
place.
Note
: Ensure the filter is placed into the door with the flat side of the
filter down, otherwise, the filter will not be secured into the door
properly.
6.
Push door back into place to latch.
Steps 1 and 2
Step 3
Steps 4, 5, and 6
