System Overview
CoolSculpting® Elite
System User Manual
16
CS-UM-CM3-02-EN-D
Power Cord Clamp
The power cord clamp attaches the power cord to the rear of the control unit, and it acts as a strain
relief to protect the Power Receptacle if the cord is pulled. Install the power cord clamp before using
the system. If the power cord is dislodged during a treatment, the treatment will be ended abruptly.
►
To install the power cord clamp:
1. On the back of the control unit, insert the thumbscrew into the hole in the base.
2. Using your fingers, turn the thumbscrew until it is snug. See illustration below.
Example:
Power cord clamp installed in base
►
To power on the control unit:
1.
Insert one end of the power cord into the power receptacle.
2.
Insert the other end of the power cord into a grounded wall outlet.
To minimize the risk of electric shock, connect this
equipment to a grounded electrical outlet.
3.
Press the power switch on the back of the control unit to the “On” position (Figure 4).
The control unit powers on and illuminates the soft power button (Figure 5).
Figure 4: Close-up of power receptacle and power switch
A; Power receptacle
B: Power switch (current position is “Off”, which is the “0”. The “On” has a “1”)
►
To power off the control unit:
1. Press the power switch on the back of the control unit to the Off position.
2. Unplug the power cord from the wall outlet.
3. Unplug the power cord from the power receptacle on the rear of the control unit.
