Zapi ACE0 2mC, Руководство пользователя

Страница: 33 / 155

AF6ZP0CA – COMBIAC0 & ACE0 2uC – User Manual Page – 33/155
potentiometers is available on pin A8 in substitution of EV5 output.
Output voltage is configurable via hardware by internal jumper to +12V or +5V;
maximum output current is 100 mA.
4
Actual values for “+12V” and “+5V” are respectively 13.1 V ± 0.5 V and
5 V ± 0.3 V.
Protection
Analog supply output is protected against over current with a thermal shut down
and protected against accidental connection to +B with a diode.
Connector position
GND A5 , PPOT (+5/+12) A8 .
4.4.13 CAN bus
CAN bus interface is available for communication with the controller, featuring:

Physical Interface according to ISO 11898-2.

Data rate can be 125, 250 or 500 kbit/s.

CAN driver is +5 V supplied and provides a rail to rail signal on the
differential output (CANH - CANL).

An internal 120 Ω termination resistor can be built-in.

Common-mode filter (resistors and capacitor) is present.
Protection
CAN bus interface is protected against accidental connection to +B and -B and
ESD protected.
Connector position
CANL A27 , CANH A28 .
4
CAN-cabling shall use a pair of twisted wires for CANH and CANL wires.
The CAN wiring shall have a characteristic impedance of 120
Ω and both
physical ends of the CAN bus shall be terminated with 120 Ω between CANH and
CANL for best possible noise immunity.