Zapi ACE0 2mC, Руководство пользователя

Страница: 103 / 155

AF6ZP0CA – COMBIAC0 & ACE0 2uC – User Manual Page – 103/155
The diagnosis is made in 4 points:
1)
Diagnosis on start-up that checks: watchdog circuit, current sensor, capacitor
charging, phase's voltages, contactor drives, can-bus interface, if the switch
sequence for operation is correct and if the output of the accelerator unit is
correct.
2)
Standby diagnosis in standby that checks: watchdog circuit, phase's
voltages, contactor driver, current sensor, can-bus interface.
3)
Diagnosis during operation that checks: watchdog circuits, contactor driver,
current sensors, can-bus interface.
4)
Continuous diagnosis that check: temperature of the inverter, motor
temperature.
Diagnosis is provided in two ways: the console can be used, which gives detailed
information about the failure, but the failure code is also sent on the CAN bus.
10.3 Alarms from master µC
Error code Effect Condition
Restart
procedure
MDI /
LED
CODE
CAN
OPEN
CODE
ZAPI
CODE
WAITING FOR NODE
MC is opened, EB is applied,
Traction/Pump stopped
Start-up, stand-by,
running
Key re-cycle
0 0000 224
BATTERY LOW
According to parameter
BATTERY CHECK (SET
OPTIONS list, paragraph 8.2.2).
Start-up, standby,
running
Battery recharge,
key re-cycle
0 FF42 66
DATA ACQUISITION Traction is stopped
Controller
calibration
Traction request
0 0000 247
CHECK UP NEEDED Start-up
Check-up done,
key re-cycle
0 0000 249
RPM HIGH
MC is opened, Traction/Pump
stopped
Start-up, standby,
running
0 FFA1 161
BUMPER STOP Traction is stopped
Start-up, standby,
running
0 FFA2 162
WARNING SLAVE
It depends on the supervisor uC 1 FF01 244
ACQUIRING A.S. Sensor Acquiring Key re-cycle
2 FFAB 171
ACQUIRE END Sensor Acquiring Key re-cycle
2 FFAD 173
ACQUIRE ABORT Sensor Acquiring Key re-cycle
2 FFAC 172
SIN/COS D.ERR XX
MC is not closed, EB is applied,
Traction/Pump, valves stopped
running Key re-cycle
3 FFA8 168