YASKAWA MOTOWELD-E500-6N3, Инструкция по эксплуатации

Страница: 29 / 115

HW0482309
29
9 Checking the
indicated value
on the panel face
Check the settings for the voltage, current, wire feeding
speed, and welding type of the digital meter on the panel
face.
Check the indicated value on the panel by changing
command value from the robot controller.
10 Wire inching
Adjust the welding wire by wire inching so that it can be used
for welding as follows:
1. Output the inching command from the robot controller.
2. Inch the wire until it comes out from the end of the torch.
11 Adjusting gas
flow
Adjust the gas flow as follows:
1. Press the “Gas” button on the panel of welder. The LED
indicator lights and the gas flows for 20 seconds. The gas
automatically stops after the 20 seconds.
(The gas flow time can be set by the parameter C00.
Refer to 4-2-8.)
2. Turn the valve of the gas cylinder counterclockwise to
open.
3. Turn the knob of the gas regulator to adjust the flow
according to welding conditions. Proper gas flow rate is
10 to 20 liters per minute. The flow rate must be
increased in proportion to the welding current (the higher
the current, the larger the flow rate).
12 Saving welding
conditions
Save the conditions before turning OFF the welder as follows:
1. Keep on pressing the “Record” button for more than three
seconds to save changes.
2. The LED indicator turns OFF while the conditions are
being recorded. Release the “Record” button and wait for
approximately three seconds. Do not turn OFF the welder
while waiting.
3. The LED indicator lights ON again at the completion of
the saving. Confirm that the LED indicator lights again.
For details, refer to 4-2-6.
13 End