Yamaha MBK MW125 2014, Руководство по обслуживанию

Страница: 210 / 380

ENGINE REMOVAL
5-7
EAS30251
INSTALLING THE ENGINE
1. Install:
• Stoppers “1”
• Collars “2”
(to the engine “3”)
2. Install:
• Engine bracket “4”
• Engine mounting bolts/nuts (rear side) “5”
• Engine mounting bolts/nuts (front side) “6”
(to the engine “3”)
TIP
Do not fully tighten the nuts.
3. Tighten:
• Engine mounting nuts (front side) “6”
TIP
With the stoppers “1”, collars “2”, engine bracket
“4”, and engine mounting bolts/nuts (rear side)
“5” positioned as shown in the illustration, tighten
the engine mounting nut (front side) on the right
side, and then tighten the nut on the left side.
4. Tighten:
• Engine mounting nuts (rear side) “5”
5. Install:
• Engine bracket bolt/nut “7”
TIP
Do not fully tighten the nut.
6. Install:
• Rear shock absorber assemblies “8”
7. Tighten:
• Engine bracket nut “7”
TIP
Before tightening the engine bracket nut, place
the vehicle on the centerstand so that the rear
wheel is elevated.
8. Check:
• Stoppers installation
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Raise the centerstand so that the rear wheel
is on the ground.
b. Make sure that the stoppers “1” are not touch-
ing the engine “3”.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
T
R
.
.
Engine mounting nut (front side)
50 Nm (5.0 m·kgf, 36 ft·lbf)
T
R
.
.
Engine mounting nut (rear side)
28 Nm (2.8 m·kgf, 20 ft·lbf)
A
A
A-A
1
4 4
1 2
5 5
5
6
2
T
R
.
.
Rear shock absorber assembly
upper nut
28 Nm (2.8 m·kgf, 20 ft·lbf)
Rear shock absorber assembly
lower bolt
16 Nm (1.6 m·kgf, 12 ft·lbf)
T
R
.
.
Engine bracket nut
54 Nm (5.4 m·kgf, 39 ft·lbf)
3
1