Security
WorkCentre 7800 Series Multifunction Printer
99
System Administrator Guide
4.
In the Security Parameter Index: IN field, type a 32-bit number larger than 256 that identifies the
inbound Security Association (SA).
5.
In the Security Parameter Index: OUT field, type a 32-bit number larger than 256 that identifies the
outbound Security Association (SA).
6.
If you selected ESP under IPsec security, under Hash, select an option.
7.
Under Enter Keys as, select
ASCII format
or
Hexadecimal number
.
8.
For Hash Key: IN and Hash Key: OUT, type a 20-character ASCII key or 40-character Hexadecimal
key.
9.
If you selected ESP or BOTH for the IPsec Security type, under Encryption, select an option.
Note:
If you are configuring an IPsec security policy to communicate with a Linux computer, and
you selected BOTH for the security type, select 3DES encryption. If you select AES encryption, the
data transfer rate is reduced.
10.
For Encryption Key: IN and Encryption Key: OUT, type a 24-character ASCII key or 48-character
Hexadecimal key.
11.
Click
Save
.
Configuring Internet Key Exchange Settings
IKE is a keying protocol that allows automatic negotiation and authentication, anti-replay services, and
CA support. It can also change encryption keys during an IPsec session. IKE is used as part of virtual
private networking.
IKE Phase 1 authenticates the IPsec peers and sets up a secure channel between the peers to enable IKE
exchanges. IKE Phase 2 negotiates IPsec SAs to set up the IPsec tunnel.
1.
Under IKE Phase 1, in the Key Lifetime field, type the length of time until the key expires in
Seconds
,
Minutes
, or
Hours
. When a key reaches this lifetime, the SA is renegotiated and the key is
regenerated or refreshed.
2.
Select the DH Group from the following options:
−
Group 2
provides a 1024-bit Modular Exponential (MODP) keying strength.
−
Group 14
provides a 2048-bit MODP keying strength.
3.
Under IKE Phase 2, select the IPsec Mode. Options are
Transport Mode
or
Tunnel Mode
.
Note:
Transport mode only encrypts the IP payload, whereas Tunnel mode encrypts the IP header
and the IP payload. Tunnel mode provides protection for an entire IP packet by treating it as an
Authentication Header (AH), or Encapsulating Security Payload (ESP).
4.
If you selected Tunnel Mode, under Enable Security End Point Address, select the address type.
Options are
Disabled
,
IPv4 Address
, or
IPv6 Address
.
5.
Under IPsec Security, select
ESP
,
AH
, or
BOTH
.
6.
Type the Key Lifetime, and select
Seconds
,
Minutes
, or
Hours
.
7.
Under Perfect Forward Secrecy (PFS), select
None
,
Group 2
, or
Group 14
.
Note:
PFS is disabled by default. PFS allows faster IPsec setup, but is less secure.
