WPI MICRO-ePUMP, Инструкция по эксплуатации

Страница: 19 / 32

MICRO-ePUMP
World Precision Instruments 15
• Disable or enable the MICRO-ePORE™ continuity test tone.
• Change the MICRO-ePUMP mode (manual or timed).
• Change the pressure units displayed on the main screen (PSI or kPa).
3. Press the BACK button to save the settings and return to the main screen.
Saving a Protocol
After you have adjusted the parameters, you can save the set of parameters as a
protocol. MICRO-ePUMP will store up to three (3) protocols.
1. Set the parameters, as desired.
2. Press the Settings section on the touchscreen to access the Settings menu.
Fig. 29—The Settings menu lets you save a protocol or load a saved protocol.
3. To save the existing set of parameters from the main screen, press the SAVE1,
SAVE2 or SAVE3 button. The parameters are saved in Protocol 1, Protocol 2 or
Protocol 3, depending on which SAVE button you chose.
4. Press the BACK button to return to the main screen.
Loading a Protocol
Saved protocols may be recalled, and this loads the saved parameters for use. When
a protocol is loaded, the protocol number (1, 2 or 3) appears in the box located in the
upper left corner of the main screen.
1. Press the Settings section on the touchscreen to access the Settings menu.
Fig. 30—The Settings menu lets you save a protocol or load a saved protocol.
2. To bring up a saved protocol with the MICRO-ePUMP parameters, press the
LOAD 1, LOAD2 or LOAD3 button. The unit loads the saved parameters of
Protocol 1, Protocol 2 or Protocol 3, depending on which LOAD button you chose.
3. Press the BACK button to return to the main screen.