WPI MICRO-ePUMP, Инструкция по эксплуатации

Страница: 16 / 32

12 World Precision Instruments
OPERATING INSTRUCTIONS
Changing the Injection Parameters
1. Press anywhere in the settings area to access the Settings menu. Press Port Off to
turn on the pressure port (PORT ON).
Fig. 19—(Left) Touch the setting area in the bottom right corner to access the Settings menu.
Fig. 20—(Right) Touch the Port OFF button to enable the injection port.
2. To change the parameters, just touch the screen on the parameter you want to
change. A box appears around the parameter to highlight it. Adjust the parameter
by turning the knob. To change the dial adjustment speed, press the knob on the
front of the MICRO-ePUMP . The snail changes the display in 0.01 increments,
and the running man changes it in increments of 0.1.
Fig. 21—(Left) Touch the parameter you want to adjust and rotate the knob to modify the
parameter.
Fig. 22— (Right) Press the knob to toggle between gross and fine tuning adjustments.
3. Two seconds after a parameter is adjusted, it is saved into the memory. If you move
from one parameter to the next before two seconds, the first parameter is automatically
saved into the memory as the working parameter. This setting will be recalled on power
up.
NOTE : This is different from saving parameter sets (protocols) to load.