Woodway ST PPS 43 Med, Руководство пользователя

Страница: 61 / 122

55 | UM-PP-EN-03
6.5.9 Bearing Guide
Required Tools
•
Socket wrench with 3” extension, #17
•
Wrench, ½”
• Ring fork wrench, #17
Removal
If the bearing guide is damaged and needs to be replaced, remove the guide by the following steps:
1. Disconnect the treadmill from the power source.
2. Remove the side covers (see Section 6.5.1 Page 46).
3. Remove the bearing guide fastening screws.
4. Unscrew the threaded pins from the bearing sleeve.
5. Using an extractor device, pull the bearing guide from the side of the unit.
Replacement
Once the bearing guide has been removed, an authorized replacement guide can be installed as
follows:
1. Replace the bearing guide in the reverse order of removal.
2. Tighten the screws to approx. 54 ft-lbs. (screw the studs tight).
6.5.10 Belt Roller Guide and Track Rollers
Required Tools
•
Socket wrench with 3” extension, #13
Removal
Ring fork wrench, #13
If the belt roller guide or track rollers are damaged and need to be replaced, remove them by the
following steps:
1. Disconnect the treadmill from the power source and remove the side cover.
2. Remove the roller unit, screw, and nut.
Replacement
Once the guide or rollers have been removed, authorized replacement parts can be installed as
follows:
1. Replace the new guide or roller in the reverse order of removal. It is acceptable to use the old
screw and nut.
2. Tighten the screw and nut to 18.8 ft-lbs.
6.5.11 End Switches
Removal
If the end switches are damaged and need to be replaced, remove them by the following steps:
1. Disconnect the treadmill from the power supply then remove the right-hand side cover (in
running direction).