56 | UM-PP-EN-03
2.
Disconnect the cable from the old end switch unit (switch to be replaced).
3.
Remove the bracket and end switch.
Replacement
Once the bracket and end switch have been removed, an authorized replacement switch can be
installed as follows:
1.
Install the new end switch unit.
2.
Replace the side cover.
6.5.12
Incline Motor
Required Tools
•
Socket wrench, 10 mm
Removal
If the incline motor is damaged or faulty and needs to be replaced, remove the motor by the following
steps:
1.
Disconnect the treadmill from the power supply and remove the side cover (see Section 6.5.1
Page 46).
2.
Loosen the motor cable and disconnect it from the control unit.
3.
Unscrew the 4 incline motor attachment screws and remove the motor from the unit.
4.
Remove the motor screws and pull the motor from the frame of the treadmill.
Replacement
Once the motor has been removed, an authorized replacement motor can be installed as follows:
1.
Replace the new motor in the reverse order of removal.
2.
Make sure to tighten the screws to 12.3 ft-lbs.
Содержание ST PPS 43 Med
Страница 22: ...16 UM PP EN 03 2 7 EC Declaration of Conformity Fig 1 EC Declaration of Conformity...
Страница 26: ...20 UM PP EN 03 3 5 Dimensions Fig 3 Device dimensions PPS Bari Mill 43 Fig 4 Device dimensions PPS Bari Mill 55...
Страница 27: ...21 UM PP EN 03 Fig 5 Device dimensions PPS Bari Mill 70 Fig 6 Device dimensions PPS Med 43...
Страница 114: ...108 UM PP EN 03 12 Maintenance Report DATE MAINTENANCE MEASURES FROM REMARKS...
