Wilo Wilo-SiFire FIRST, Инструкция по установке и эксплуатации

Страница: 51 / 84

Switchgear of diesel pump en
Installation and operating instructions Wilo-SiFire FIRST 51
ƒ
The alarm can only be reset if the start is successful.
10.1.3 Procedure for commissioning
Fig. 12.3
ƒ
From this page, by pressing the key , it is possible to test the signalling LEDs
on the front panel.
ƒ
From this page, pressing the key , will start the motor by simulating the lack
of signal from the pressure switch. The duration and pause of the starting attempts
are those foreseen by the standard in the commissioning test on site.
ƒ
Each time the tests are performed, the date of execution is saved and shown on the
display.
ƒ
Detection of the motor speed: The setting is protected by the extended password
when activated. Start the motor. When the motor reaches the RPM with a constant
speed, press and simultaneously to start the automatic motor RPM
acquisition procedure. During the procedure it is still possible to increase and de-
crease the motor RPM value. By pressing it decreases and with it in-
creases.
NOTICE
This procedure is also useful for checking the state of the batteries: In the event that
a correct value voltage is measured at the ends of a battery due to the voltage gen-
erated by the battery charger, it may happen that this value drops sharply during
start-up.
10.1.4 Main menu
Fig. 12.4
Description
1
Password entry - Setting the numerical code that allows access to protected
functions (setting parameters, execution of commands)
2 Main page access
3
Battery status
4
Commissioning
5
Fuel tank status
6
Counters
7
Events list
8
Input/output status
9
Alert status
10
System information
11
Settings – Access point for parameter programming
12
Command menu – Access point to the command menu where authorised
users can perform a series of reset and restore actions
ƒ
The main menu consists of a set of graphic icons that allow quick access to meas-
urements and settings.
ƒ
Starting from the page display, press the button . The display shows the
quick menu.
ƒ
Press or to rotate clockwise/counterclockwise until the desired
function is selected. The selected icon is highlighted and the text in the central part
of the display indicates the description of the function.