9
1.
The Vacuum Pump must be charged in a well-ventilated area
between the temperatures of 5 °C (41 °F) and 32 °C (90 °F).
Charging outside of this range may result in prolonged or
incomplete charging and may damage your Vacuum Pump.
Only charge the Vacuum Pump in a well ventilated
area at a temperature between 5 °C (41°F) and 32°C
(90°F). Charging outside of these conditions may
damage the Vacuum Pump.
A Vacuum Pump enclosed by a cosmetic cover will
retain heat, but in most cases should charge normally
at temperatures below 27°C (80°F). The battery may
not fully charge at higher temperatures.
2. Insert the charging plug all the way into the charging port.
3. Plug the Charger into a power outlet. The Adapter LED will
light. If the Node LED does not light, make sure you have
inserted the charging plug all the way into the port.
If the Node LED is red, reset the Charger by unplugging it
from the wall and plugging it back in.
While charging is in progress, the Node LED will be solid. The
battery indicator on the fob will flash alternately between red
and green.
4. When charging is complete, the Node LED will flash.
Disconnect the Charger from the Vacuum Pump and from
the power outlet.
When you are ready for the pump to begin regulating the
vacuum, either turn on the fob (refer to page 11) or press the
on/off button
on the Vacuum Pump. The pump will operate
until the preselected vacuum level is reached.
Note: Your pump can be used while charging. If the pump has
just been unplugged from the Charger, it will be in Standby State
(refer to page 11). To resume vacuum regulation, press the on/off
button one time for Active State. Press again to turn the pump off.
Walking while charging your pump may cause you to trip
and fall. Do NOT walk while your LimbLogic is plugged into
the charger.
Use ONLY a WillowWood Charger. Use of any other charger
may result in damage to the Vacuum Pump or the charger
or both and may negatively affect EMC performance and/
or compliance and may result in serious injury or death.
The charger may pose both a strangulation and/or
electrocution hazard and should not be handled by children.
Do not use the Charger near water. The Charger is
not waterproof. Use of the charger near water may
result in serious injury or death.
Overview
CHARGING THE VACUUM PUMP BATTERY
The Vacuum Pump should be charged before it is used for the
first time, at the end of each day of use, and when the Battery
Indicator on the fob is red.
Node LED
(indicates Charger function)
RED = fault
SOLID = charging
FLASHING = charged
Flashing:
Charged
13.8 0V
LLV-21011
solid:
Charging
2012 PN-1988-H
ABN: 22582837497
charging port
Charger
Vacuum Pump
To AC outlet
charging plug
Adapter LED
(indicates that
AC outlet is
providing power
to Charger)
Node LED
AC Adapter