widos 5000 WM, Руководство по эксплуатации

Страница: 46 / 94

Foundation: 2207, 2208 DIN 16932 German association for welding
Use for:
5000 WM / 5002 WM (with 2. cylinder)
1 bar on manometer: 94 N
PE 80 The value for heating element temperature is between 200° C - 220° C.
The smaller the pipe wall the higher the temperature.
PE 100 The standard value for heating element temperature is 220° C.
Increase the change-over time and the welding pressure time at PE 100 as fast as possible !
time to
change- reach full
over welding cool-down time
0,15 (PE) time pressure
pressure in
T
desired
temperature
time
The following pressure values are only valid if the 2. cylinder is used.
pipe pipe SDR bead-up circular heat-up max. time welding cool-
diameter wall pressure bead time change- to reach pressure down
OD (s) [bar] min. [s] over welding [bar] time
[mm] [mm] [mm] time pressure [min]
[s] [s]

160
4,0 41 4 0,5 40 5 5 4 5
160 4,9 33 4 1 49 5 5 4 7
160
6,2 26 5 1 62 6 6 5 9
160 7,7 21,0 6 1,5 77 6 6 6 11
160
9,1 17,6 7 1,5 91 7 7 7 13
160 9,5 17 8 1,5 95 7 7 8 13
160 11,8 13,6 9 2,0 168 9 10 9 21
160 14,6 11 11 2 146 9 9 11 19
160 17,9 9,0 13 2,0 179 10 11 13 23
160 21,9 7,4 16 2,5 219 11 12 16 27
180 4,4 41 4 0,5 44 5 5 4 6
180 5,5 33 5 1 55 5 5 5 8
180 6,9 26 6 1 69 6 6 6 10
180 8,6 21,0 8 1,5 86 7 7 8 12
180 10,2 17,6 9 1,5 102 7 7 9 14
180 10,7 17 10 1,5 107 7 7 10 14
180 13,3 13,6 12 2,0 133 8 9 12 17
180 16,4 11 14 2 164 9 10 14 21
180 20,1 9,0 17 2,5 201 10 11 17 25
180 24,6 7,4 20 2,5 246 12 13 20 30
in welding area
Table for PE
bead-up heat-up
Additional to the given bead-up force and to the welding force the moving force of the support must be added !
welding area
P (N/mm²)
23.06.2015
Working instructions WIDOS 5000 WM / 5002 WM with 2
nd
cylinder
Page 39 / 1 of 80