widos 5000 WM, Руководство по эксплуатации

Страница: 63 / 94

WIDOS Einsteinstr. 5 Phone +49 (0) 71 52 99 39 0
Wilhelm Dommer Söhne D-71254 Ditzingen-Heimerdingen Fax +49 (0) 71 52 99 39 40
GmbH Website: www.widos.de Email: info@widos.de
23.06.2015 Working instructions WIDOS 5000 WM Page 49 of 80
8. Equipment care / maintenance / repair
Goal of the chapter is:

Keeping the nominal state and the operation capacity of the machine.

Efficient planning of the maintenance works and the maintenance tools

Increasing the efficiency by avoiding non-planned outage.
8.1. Transport

Make sure that the machine is exposed to no hurts.

Treat the machine carefully, pay a special attention to electric cable and pneumatic hose.
8.2. Maintenance, Inspection and repair

The operating staff has to be informed before the starting of the maintenance works.
All maintenance and repair works have to be basically performed with the machine in off
position.
During this the machine has to be secured against unauthorized switching on.
Prescribed maintenance and inspection works should be performed in time. The DVS gives
the advice of inspection works after 1 year.
For machines with an especially high usage percentage the testing cycle should be shortened
to 1000 welds.
The works have to be performed at the WIDOS GmbH company or by an authorized partner.

In general, take care for cleanness!

Handle the machine carefully.

Immediately replace damaged parts, take especially care with electric parts.
The linear guides for heating element and planer must be cleaned every week e.g. with a
brush.
Check the linear guide carriages every 12 months and grease them over the lubricating
nipple if necessary.
Chips or other impurities in the guides can be the cause if the heating element or the planer
jam or run heavily.

Clean the piston rods every month with an oily tissue.

Check the hydraulic connections every month for tightness, tighten again if necessary.

Check the tightness of loosened screws.

Check the function of the safety devices after completion of the maintenance works. Especially insulation,
tension resistance and protective cables resistance.