widos 5000 WM, Руководство по эксплуатации

Страница: 37 / 94

Foundation: 2207, 2208 DIN 16932 German association for welding
Use for:
5000 WM / 5002 WM
1 bar at manometer: 71 N
PE 80 The value for heating element temperature is between 200° C - 220° C.
The smaller the pipe wall the higher the temperature.
PE 100 The standard value for heating element temperature is 220° C.
Increase the change-over time and the welding pressure time at PE 100 as fast as possible !
time to
change- reach full
over welding cool-down time
0,15 (PE) time pressure
pressure in
T
desired
temperature
time
pipe pipe SDR bead-up circular heat-up max. time welding cool-
diameter wall pressure bead time change- to reach pressure down
OD (s) [bar] min. [s] over welding [bar] time
[mm] [mm] [mm] time pressure [min]
[s] [s]

in welding area
Table for PE
bead-up heat-up
Additional to the given bead-up force and to the welding force the moving force of the support must be added !
welding area
P (N/mm²)
200 4,9 41 7 1,0 49 5 5 7 7
200 6,2 33 8 1,0 62 6 6 8 9
200 7,7 26 10 1,5 77 6 6 10 11
200 9,6 21,0 13 1,5 96 7 7 13 13
200 11,4 17,6 15 1,5 114 8 8 15 15
200 11,9 17 15 1,5 119 8 8 15 16
200 14,7 13,6 19 2,0 147 9 9 19 19
200 18,2 11 22 2,0 182 10 11 22 23
200 22,4 9,0 27 2,5 224 11 12 27 28
200 27,4 7,4 32 3,0 274 13 15 32 34
225 5,5 41 9 1,0 55 5 5 9 8
225 6,9 33 10 1,0 69 6 6 10 10
225 8,6 26 13 1,5 86 7 7 13 12
225 10,8 21,0 16 1,5 108 8 8 16 15
225 12,8 17,6 19 2,0 128 8 8 19 17
225 13,4 17 19 2,0 134 8 9 19 18
225 16,6 13,6 23 2,0 166 9 10 23 21
225 20,5 11 28 2,5 205 10 12 28 26
225 25,2 9,0 34 2,5 252 12 14 34 31
225 30,8 7,4 40 3,0 308 14 16 40 38
23.06.2015 Working instructions WIDOS 5000 WM / 5002 WM Page 36 / 2 of 80