4-18
REMOVING THE DRAIN PUMP
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
1.
Unplug washer or disconnect power.
2.
Turn off the water supply to the washer.
3.
Tape the lid closed and lay the washer on
its rear panel so that you can access the
bottom of the unit.
4.
Disconnect the wire connectors from the
drain pump terminals.
5.
Loosen the clamp, disconnect the hose
from the drain pump, and drain the water
from the hose and pump into a container.
6.
Remove the three hex-head screws from
the drain pump housing and remove the
housing assembly from the washer.
Drain Pump
7.
Remove the four screws from the drain
pump and remove the pump from the
housing.
Wire Connectors
Hose
Hex-Head Screws
NOTE:
Inspect the rubber seals on the drain
and pump housing. If they are worn or cracked,
replace the seals.
4 Screws
Rubber Seals
Drain Pump
Drain Pump
Housing
