Wheatstone Corporation D-9, Техническое руководство, Страница: 52 / 124

D Y N A M I C S P R O C E S S I N G C O N T R O L P A N E L
page 5 – 5
D-9 / Oct 2003
the process for each of the 8 MXM outputs in the MXM MASTER section
on the EFS panel.
To DEselect a source, select that source by means of SOURCE knob,
and press the CLEAR button.
After a timeout period of 5 seconds the INPUT NAME display will
revert to the current channel that’s in SET mode elsewhere on the control
surface.
Talkback Preselects
These four switches allow for a dedicated Bridge Router output to be
designated as a destination for the talkback signal. Once a specific output
has been programmed into the preselector, the talkback signal can be sent
to that output at any time by pressing the corresponding switch.
Each of the four TB buttons can be individually programmed, and
then the entire programmed bank of four can be stored and recalled in the
EVENT CONTROLLER section (see pages 3-12 to 3-14). Each indi-
vidual TB button is programmed as follows: press the PGM/TAKE
button (this button will light), then press the TB button you want to
program (the TB button and its associated display will flash). Then rotate
the SELECT knob (programmable section on the EFS panel) and
available destinations will be shown in the SOURCE display. When the
desired channel is shown, press TAKE button located next to the
SELECT knob (EFS-D9 panel), and the appropriate TB PRESELECTS
display will then match what is shown in the SOURCE display on the EFS
panel. Repeat this procedure for each of the four TB buttons. The
procedure will time out after about 5 seconds if you fail to complete one
of the steps.
When EVENTS are stored, the four TB preselects as displayed at the
time of the EVENT SAVE action will be also stored and can be recalled
with that EVENT.
DCM-D9 Panel EFS-D9 Panel