Wheatstone Corporation D-9, Техническое руководство, Страница: 38 / 124

C O N T R O L P A N E L
page 3 – 14
D-9 / Oct 2003
Event Default Button
This control allows rapid access to a default or home control surface
setting. Push it, and the TAKE button in the Preview section will flash.
Hit the TAKE button and the default setting will be executed.
Establishing the Default Setting
This setting would normally be set only once. For example, it may
be desirable to have all controls set to zero, or everything programmed
to typical nominal settings. To establish the default setting, adjust all the
control surface controls to their desired settings, press the MODIFY
button and then the DEFAULT button. The default setting is stored.
Naming an Event
When events are saved, they receive a default event
designation number. This way events can be saved
quickly without having to name them. However, an
event may be custom named when saved, or at a later
time. To rename the displayed event, press the ALPHA
SCROLL knob. The CURSOR LT and CURSOR RT
buttons will light and the cursor, indicated by a flashing
character, will be at the beginning of the name. Also, the
SAVE button will begin to flash. At any time you can use
CURSOR LT and CURSOR RT to move to a character
you want to change. Once the cursor is at the desired
character, rotate the ALPHA SCROLL encoder until the
desired new character is displayed. Once all desired
characters have been changed, simply press SAVE to
save your changes. The event is stored with the desired
name. At any time you can cancel the name edit by pressing the ALPHA
SCROLL knob. Also, if you stop making name changes but fail to press
the SAVE button, the name edit process will automatically cancel after
a delay of several seconds.
Control Modes
The D-9 control surface is operated in one of three modes. In
Administrator mode access is allowed to all surface functions. In User
mode a limited set of user functions is allowed. The set of functions
allowed in User mode is set independently for each console using the
Bridge XPoint software (see the Bridge Router manual for details). The
third mode, Guest, blocks out MXM level, MXM assign, Event takes,
and visibility changes from being controlled by the surface.
To change the control mode, begin by pressing and holding the
PREVIEW SCROLL knob until the display reads “Admin” and the
TAKE button lights (if the surface is currently in Admin mode the ARM
button will also light). Turn PREVIEW SCROLL until the desired new
mode (Admin, User, or Guest) is showing in the display and press
TAKE. Turn PREVIEW SCROLL again to select the first digit of the
D-9 / Dec 2004