Terrazza Originale
Instructions for assembly
Version 5
12.06.2017
We reserve the right to make technical changes
Item number
111361-0000
Page 89/104
5.3.3 Fitting roof supports to an angled wall bracket
The roof supports are always fitted vertically to the guttering.
The roof supports are attached to the angled wall bracket using two 20 mm wide clamping
sliders.
To fit the roof supports, the roof supports must be positioned between the clamping sliders
and the wall bracket glazing beads from the front.
Then place the roof supports over the clamping sliders and affix.
Seal around the roof supports and wall bracket.
Important! Do NOT deviate from this installation sequence under any circumstances (See
"Fitting the wall bracket glazing beads" and "Fitting roof supports to an angled wall
bracket"). The wall bracket glazing beads cannot be fitted if the roof supports have already
been installed.
Figure: Fitting roof supports to an angled wall bracket
1
Dubo retaining ring M5
2
Clamping slider
3
Angled wall bracket
4
Wall bracket glazing beads already fitted
M5
WS 8
