Terrazza Originale
Instructions for assembly
Version 5
12.06.2017
We reserve the right to make technical changes
Item number
111361-0000
Page 97/104
5.4.3 Fitting the roof supports to an angled gutter
The roof supports are fitted to the angled gutter using two 20 mm wide clamping sliders.
The side roof supports on the angled guttering must be secured using an additional
clamping slider to prevent them from sliding off to the side, taking both the roof pitch
and the angle of the angled guttering into account.
This will require filling the gap between the roof support clamping slider and the cut
edge of the guttering with clamping sliders. Trim the clamping sliders to size if
necessary.
Leave 2 - 3 mm of play between the inserted clamping slider and the cut edge of the
guttering to allow the guttering to compress.
Figure: Affixing the roof support to the guttering
1
Additional clamping slider to prevent guttering from
sliding off to the side
2
Dubo retaining ring M5
3
2-3 mm play to allow guttering to compress
M5
