![background image](http://html1.mh-extra.com/html/weinor/terrazza-originale/terrazza-originale_instructions-for-assembly_953085048.webp)
Terrazza Originale
Instructions for assembly
Version 5
12.06.2017
We reserve the right to make technical changes
Item number
111361-0000
Page 48/104
4.3 Fitting the roof support to the corner connector
Before the roof supports can be screwed together, the clamping sliders for the transoms must
first be inserted into the groove on the roof support. When doing this, make sure that the
clamping sliders are in the right position.
Coat the front of the roof supports along the ridge with a suitable adhesive and sealant.
Slide the roof supports onto the corner connectors and, if necessary, gently tap in place using a
rubber mallet until the two roof supports fit together snugly.
Screw the roof support onto the corner connector.
Then clean off any residual adhesive and sealant along the joints on the outside of the roof
supports.
Figure: Fitting the roof support to the corner connector
25
Slide the roof support onto the corner connector and affix with screws
26
Once these are connected, clean off any residual adhesive and sealant on the outside of the roof
support
27
Corner connector
28
Clamping slider
29
Tapped hole; facing the ridge
30
Countersunk hole; facing lower end of roof support
M6x30