WEIHONG LS6000M, Руководство пользователя

Страница: 35 / 121

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
.
32 / 116
3. Open NcStudio . Set the axis station address parameters to the values set by the
drive front panel.
3.5 Set Bus System Parameters
If you are using a bus system, set the bus system parameters.
Follow the steps below to set the bus system parameters:
1. In the function bar, click Set .
2. Click the System Parameters tab:
3. Click the pull-down menu in the lower-left corner and select Manufacturer .
4. Double-click and set the following parameters:
o
Drive station address (X/Y1/Y2) : The values need to be the same as those
set by the drive rotation switch. 0 is ineffective.
o
Encoder Digits (X/Y1/Y2) : The digit number of the servo motor encoder.
o
Numerator of Electronic Gear Ratio : Set it to the numerator of the axis
electronic gear ratio.
o
Denominator of Electronic Gear Ratio : Set it to the denominator of the axis
electronic gear ratio.
o
Axis direction
o
Encoder direction
3.6 Set Speed Parameters
You can set basic speed parameters to adjust machining speeds.
Follow the steps below to set speed parameters:
1. In the function bar, click Set .