5. Enter the Iperf command
“Iperf –c <IP address of Server PC> -w 65535” to start the client communication to
the server.
Figure 108 Iperf Client
This command runs a test over the radio link to the server PC and reports back the results, as shown
in Figure 109. These results show the bandwidth (throughput) of the test as 19.2 Kbps. We recommend that
you run the test several times to get an average.
Figure 109 Iperf Results
JPerf Application
Jperf is a graphical interface that runs over the top of Iperf and displays a graph result from the Iperf test.
1. Open a command prompt and change to the jperf-2.0.2: directory
2. Run the Jperf application, as shown in Figure 110.
The command prompt screen is replaced by the Jperf screen shown in Figure 111.
Figure 110 Command Line