Figure 3–18: Tubing connection between the diverter valve and the ESI probe
Tip:
The other plumbing connections are omitted for clarity.
Probe adaptor cap
PEEK fitting holder
Leak tray
Probe adaptor
Probe inlet PEEK fitting connected to diverter valve
Tubing
c.
Close the access door to the IntelliStart Fluidics system.
Tip:
If fluid collects in the leak tray, inspect the connection at the diverter valve.
3.2.7 Removing the probe adaptor
Remove the probe adaptor before performing any of the following actions:
• Switching between ESI and APCI modes (see
).
• Installing the Low-flow ESI probe (see the
Low-flow ESI Probe Operator's Guide
).
• Replacing the ESI probe tip or gasket (see
Replacing the ESI probe tip or gasket
).
June 9, 2016, 715004990 Rev. A
Page 60
