1.
To prepare for installing a probe assembly, press together the probe-adaptor-cap release
buttons, in the direction shown by the arrows in the following figure, and lift the probe
adaptor cap off the probe adaptor.
Figure 3–5: Probe adaptor cap release
2.
For ESI probe adaptors, remove the protective cap, if fitted, from the probe tip.
Figure 3–6: ESI probe protective cap
Protective cap
3.
Carefully slide the probe adaptor into the hole in the probe adjuster assembly, ensuring
that the probe location dowel aligns with the location hole in the probe adjuster assembly.
Figure 3–7: Probe location dowel
June 9, 2016, 715004990 Rev. A
Page 51
