Waterous AQUIS Series, Инструкции по установке, эксплуатации и обслуживанию

Страница: 73 / 90

73
|
90
Safety Introduction Product Overview Installation Operation Maintenance Troubleshooting Service Parts Warranty
4. Loosen and remove the drain plug on the bottom of the pump
( Figure 59 ).
1
2
1. Drain port 2. Drain plug
Figure 59
5. Allow the oil to drain.
6. Install the drain plug to the pump (
Figure 59 ).
7. Use the hardware that you set aside to secure the pump to the
mounting bracket ( Figure 59 ).
Adding Oil
Note: Only use SAE 30, non-detergent oil.
1. Remove the vented oil cap and set it aside
( Figure 1 , Figure 2 ,and Figure 4 ).
2. Use the chart below to determine the oil capacity of your model.
Model Oil Capacity
AQUIS 1.5 6.1 oz (0.18 L)
AQUIS 3.0 10.8 oz (0.32 L)
AQUIS 6.0
18.9 oz (0.56 L)
3. Add the specified amount of oil into the oil reserve.
4. Use the sight window to determine the oil level in the reserve.
Note:
The oil cap on the AQUIS 3.0 and 6.0 can be used to determine
the oil is at capacity.
5. Install the oil cap to the oil reserve.
Completing the Oil Change
1. Set the circuit breaker to operating position.
2. Install the cover. Refer to:
"Installing the Cover" on page 59 .