Wallenstein P3 PULSE WP1624, Руководство оператора

Страница: 40 / 88

Conveyor Setup
WP1624 Series
Firewood Processor
40
7. Conveyor Setup
7.1 Set Up a 12 ft Conveyor
1. Disconnect the conveyor from the chute lock arms.
2. Lower the conveyor using the hand winch.
For instructions, see page
38.
3. Set the conveyor height as required.
For instructions, see page
40.
7.2 Set Up a 24 ft Conveyor
CAUTION!
Park conveyor where wheels are on firm, level
ground. Never raise or move conveyor if wheels
are on uneven ground.
IMPORTANT! Failure to unlock the hitch can cause damage
when the conveyor is raised.
1. Position the conveyor below the machine discharge chute.
2. Block the conveyor wheels.
3. Remove the hitch lock pin from the conveyor hitch.
4. Disconnect the toplink pin (if connected) and place it in the
stored position.
01850
Fig. 32 –
Toplink Pin
5. Set the conveyor height as required. For instructions, see
page
40.
6. Connect the conveyor hydraulic hoses to the machine.
Conveyor pressure and return hoses have 1/2" quick-
disconnect fittings with protective caps. The red cap is the
pressure hose and the black cap is return hose.
00480
Fig. 33 –
Hose Connections
7.3 Set the Conveyor Height
This section applies to a 12 ft or a 24 ft conveyor.
The conveyor height is adjusted using the hand winch on the
left-hand side. An internal brake holds the winch at the desired
height.
Use the conveyor angle guide to set the conveyor to a safe
height. Always keep the indicator in green zone.
For more information, see page 35 .
01766
Fig. 34 –
Conveyor Angle Indicator