![Wallenstein P3 PULSE WP1624 Скачать руководство пользователя страница 49](http://html1.mh-extra.com/html/wallenstein/p3-pulse-wp1624/p3-pulse-wp1624_operators-manual_3254851049.webp)
WP1624 Series
Firewood Processor
Operating Instructions
49
With the lever
vertical
(roller unclamped) the clamp
arm holds its raised position unless the saw is
moved. Pulling the saw down to cut, the roller
clamps down on the log.
When unclamped, the clamp arm starts to raise
when the saw reaches the home position.
01441
Fig. 51 –
Top Roller Lift Arm Clamped Down on Log
00407
Fig. 52 –
Top Roller Clear for Next Log
9.6 Cut Wood
WARNING!
Risk of serious injury or death from
fl ying debris or shot from broken
saw chain. Stay behind protective
shields when cutting. Keep ground
personnel and bystanders outside
perimeter of work area.
W044
IMPORTANT! Allow adequate time during start up for bar
oil to reach the chain.
00388
Fig. 53 –
Bar Oil
IMPORTANT! In cold weather run the saw slowly while
cycling the guide bar until lubricant can be observed leaving
the tip of the guide bar. Warm the saw circuit oil by holding
the saw control valve lever forward in the RAISE position to
cycle oil back to the reservoir.
•
Pull the Saw Control lever back towards you to lower the
saw and cut the log. The saw chain starts as the saw
begins to move. The top roller holds the log in place. When
the log is cut through, the block falls into the splitting
cradle.
•
Push the lever forward to raise the saw out of the way,
ready for the next cut. The saw chain stops as the
saw is raised. The top roller keeps a slight amount of
down pressure on the log at all times unless the arm is
unclamped when the saw is raised.
Содержание P3 PULSE WP1624
Страница 18: ...WP1624 Series Firewood Processor Safety 18 Safety Signs 0 4 3 9 10 5 14 8 13 15 Fig 4 Safety Decal Locations...
Страница 62: ...Service and Maintenance WP1624 Series Firewood Processor 62 1 2 4 5 6 3 Fig 76 Lubrication Diagram...
Страница 87: ......
Страница 88: ...WallensteinEquipment com...