Wallenstein P3 PULSE WP1624, Руководство оператора

Страница: 59 / 88

WP1624 Series
Firewood Processor
Storage
59
11. Storage
After the season's use or when the machine will not be used for
a period of time, completely inspect all major systems of the
firewood processor. Replace or repair any worn or damaged
components to prevent any unnecessary down time at the
beginning of the next season.
IMPORTANT! For information on engine storage, refer to
the engine manufacturer's manual in the manual storage
tube.
11.1 Storage Safety
WARNING!
Do not permit children to play on or around
stored machinery or equipment. Sharp edges,
unexpected movement, trips, falls, and other
hazards can cause serious injury or death.
W105
• Store the machine in a dry, level location away from human
activity.
• Store the machine indoors, where possible.
• Support the frame with planks, if required.
11.2 Place the Machine in Storage
1. Clear out all wood material from the machine.
2. Do one of the following:
-
If the machine will be in storage for one to three
months, add stabilizer to the engine fuel and drain the
carburetor.
-
If the machine will be in storage for longer than three
months, replace the engine fuel with an alkylate or
appropriate engineered fuel. These fuel types prevent
the buildup of insoluble solids (deposits) in the engine.
For more information, see page
Engine Fuel on page 59 .
3. Thoroughly wash the machine to remove all dirt, mud, and
debris.
4. Inspect all moving parts and remove any entangled
material.
5. Fold up the live deck. Park the machine out of the way.
6. Block the wheels.
7. For the WP1624-12 model, place the 12 ft conveyor in the
transport position. For instructions, see page
58.
8. Cover the machine with a waterproof tarp, if storing it inside
is not possible.
11.2.1 Replace the Engine Fuel
WARNING!
Before you replace the fuel, read and understand
the information under Gas Engine Safety on page
12
.
1. Remove the current fuel from the engine.
Operate the machine until the fuel tank is empty or drain the
fuel tank and properly dispose of the fuel.
2. Add new fuel to the engine.
For instructions, see page
43 .
3. Start the machine.
For instructions, see page
46 .
4. Wait five to 10 minutes for the fuel to flush the carburetor.
5. Stop the machine.
For instructions, see page
46.
11.3 Remove the Machine from
Storage
When removing this machine from storage, follow the
Pre-operation checks. See page
42.
11.4 Place a 24 ft Conveyor in Storage
1. Clean off all dirt, mud, and debris.
2. Make sure the hose ends are capped and stored.
3. Grease the conveyor drive bearings. Apply one grease gun
shot for each bearing.
See page
70 for conveyor grease points.
4. Park the conveyor in an area that is dry, level, and free of
debris.
5. Store the conveyor so it is out of the way.
Do not allow children to play on or around it.
6. Cover the machine with a waterproof tarp, if storing it inside
is not possible.
11.5 Remove a 24 ft Conveyor from
Storage
1. Check air pressure in each tire. See tire sidewall for rating.
2. Review and follow the Pre-start Checklist on page 42.
3. Review safety information .