Wallenstein P3 PULSE WP1624, Руководство оператора

Страница: 53 / 88

WP1624 Series
Firewood Processor
Operating Instructions
53
If the firewood is less than 24", it is not
necessary to push the block completely through
the splitting wedge. Split it partially, then let the
next block following finish it.
For the best efficiency, advance the log for the
next cut as the splitter is retracting.
End of the Log
4. Use the length guide on the side of the infeed conveyor as a
reference for final log cuts. The guide indicates the length of
log remaining, measured from the saw.
9.8.1 Change the Splitting Wedge
00430
1
3
2
Fig. 64 –
Splitting Wedge
1. Linchpin
2. Wedge Pin
3. Splitting Wedge
Either a 4-way or 6-way wedge can be used on the splitter.
Wedge storage is located beside the fuel tank.
To change it, follow these steps:
1. Remove the linchpin (1).
2. Lift and support the wedge (3), then remove the wedge pin
(2).
3. Lift the wedge up over the support to remove it.
4. Install the wedge in the reverse manner.
5. Push the next block through the wedge to finish the split of
the first. The split wood is shoved out onto the conveyor as
each additional log moves through the machine.
6. Continue advancing and cutting up to the end of the log.
01868
Fig. 65 –
Splitting Wedge Storage