Wacker Neuson WL 50, Руководство оператора

Страница: 222 / 254

SE RVICING A ND INSPEC TION
220
Getting ready
Switch off all the loader‘s electrical controls. 1.
Switch the starting key to position 0. 2.
Drive the vehicle with the good battery (charged battery) 3.
near but not touching the loader.
Switch off all electrical controls on the vehicle with the 4.
good battery and stop the engine.
Connect the jumper cables
Starting the engines
Start the engine of the vehicle with the good battery and 1.
let it run at an increased speed.
Attempt to start the loader engine. 2.
If the engine does not start after 15 seconds, wait one 3.
minute before trying again.
Once the engine has started, let both engines continue 4.
to idle with the jumper cables connected for about an-
other two minutes.
Detach the jumper cables
(The correct sequence must be adhered to)
Connect the red jumper cable Item r (Fig. 104) to the 1.
positive pole of the dead battery Item L.
Connect the red jumper cable to the positive pole of the 2.
charged battery Item V (Fig. 104).
Connect the black jumper cable Item s to the negative 3.
pole of the charged battery.
Connect the black jumper cable to the negative pole of 4.
the dead battery.
(As with connecting, follow the correct sequence):
Disconnect the black jumper cable first from the nega- 1.
tive pole of the dead battery and then from the negative
pole of the charged battery.
Disconnect the red jumper cable first from the positive 2.
pole of the charged battery and then from the positive
pole of the dead battery.