Volvo EC35, Руководство оператора, Страница: 43 / 140

Operating instructions
Starting the engine 41
Starting the engine
1 Insert the ignition key into the ignition switch and turn it to "Run-
ning Position/ Preheating (I)" (position 2). All control and func-
tion lights light up for a period of approx. 3 seconds.
2 The control lights (1) preheating, (3) engine oil pressure and (5)
battery charge control must light up.
3 Turn the ignition key to position "Running Position/Preheating"
(position 2). The "Preheating " control light (1) lights up. Pre-
heat depending on engine temperature.
EC35: 15 seconds.
EC45: 15 seconds.
The preheating control light goes out after preheating.
Howe-
ver, if the ignition key remains in "Preheating" position (position
2), the preheating function remains active, even though the
control light is off.
4 Once the "Preheating" control light (2) has gone out turn the ig-
nition key to position "Ignition" (position 3) and start the engine.
As soon as the engine starts to run by its own power, release
the ignition key (the ignition key returns to "Running Position/
Preheating" (position 2)). Do not continue to start for longer
than 25 seconds without interruption.
5 If the engine does not start turn the ignition key back to "Stop
Position" and repeat the starting procedure.
NOTE! Avoid excessive loading of the engine immediately af-
ter starting. Observe the warm-up instructions.
Warm-up instructions
1 Start the engine.
2 After a longer period of standstill and particularly at temperatu-
res around or below the freezing point the engine must be war-
med up at medium speed.
3 Run the engine warm for about 5...10 minutes at approx. 1/2
engine speed. During this period frequently operate the levers
for the working hydraulics, whenever possible.
WARNING!
Do not turn the ignition key while the engine is running,
because this will generate a surge voltage and damage the
electrical system.
1
2
3
1
2
3
1
OK
2 3
= 1+2+3
11803658
1011259