Vivax Metrotech FLS-2, Руководство пользователя

Страница: 21 / 58

™
Page 15 of 49
6 Rack Installation of the Transmitter
To attach the adjustable rack mounting brackets:
1. Remove the attached mounting brackets using the Philips-head screwdriver and
save the flat-head screws.
2. If not attaching the new brackets to the same front location, remove the two pan-
head screws from the side center locations and secure them in the side front
screw locations.
3. Attach each bracket to the center screw openings with the flat-head screws. Verify
that the installed bracket position is the same for both sides.
Figure 6-2 Adjustable Rack Mounting Brackets (19-inch, 23-inch, and 24-inch).
6.5 Installing or Replacing the Transmitter
This section describes installing a new FLS-2 transmitter or replacing an already
installed transmitter.
CAUTION
We recommend that two people install or remove the transmitter.
To help prevent injury when lifting the transmitter, bend your
knees, and keep your back straight.
6.5.1 Installing the Transmitter
Follow these instructions when installing the transmitter into a rack.
To install the transmitter:
1. Attach the rack mounting brackets compatible with the rack width.
2. For instructions, see section 6.4, “Attaching the Rack Mounting Brackets.” Have
one person lift and hold the transmitter in the selected rack position.
3. Have the second person secure each mounting bracket to the rack using the
Philips-head screwdriver and two screws per bracket.
To attach the cables and cords:
1. Turn the rear power switch off.
2. Connect an external ground conductor to the rear ground stud between the
second and third lock washer.
CAUTION
The ground stud is secured to the chassis by the first lock washer
and nut – do not loosen or remove these. The external ground
conductor should be a minimum of 12 AWG.