Vivax Metrotech FLS-2, Руководство пользователя

Страница: 37 / 58

™
Page 31 of 49
8 The Hand-Held Display
8.2.7 Software Updates
Firmware updates come in the form of files with a .bin extension. The software files
can be obtained from a Vivax-Metrotech office. Before updating the firmware, note
the firmware version currently in the transmitter. After the firmware update has run,
compare the firmware versions to ensure that the update ran successfully. Check the
transmitter's firmware version by going to Settings > About and looking at the Control
Module F/W section. Note that when a firmware update is run, the Display Module and
DSP Module firmware will also be updated if needed.
FLS-TX2W
About
8/10/2021
01:43 AM
Host Name
IP Address
Control Module F/W
Display Module F/W
DSP Module F/W
Chassis S/N
Control Module S/N
Display Module S/N
FLS0000
192.168.10.108
v.2.0028
v.1.1966
v.1.1862
0102010001
N/A
0121406001
OK
Figure 8-26 The About screen showing Firmware versions
1. Put the .bin file on the root drive (not in any folders) of a USB stick and put the
USB stick into the USB port on the transmitter's front panel.
2. Enter the Settings menu by clicking on the Settings icon in the top right
corner of the hand-held unit’s display.
3. From the Settings menu click on the Software Update icon. Ensure that the USB
stick is inserted into the front panel USB port and click on OK to start the firmware
update.
FLS-TX2W Software Update
8/10/2021
01:43 AM
No Yes
Please ensure that the
USB Stick is inserted.
Figure 8-27 Insert USB Stick and click OK
4. The Updating Software, please wait message will appear. The screen will go
black and may flash a few times during the update and a Loading screen will
appear.
FLS-TX2W Software Update
8/10/2021
01:43 AM
Updating Software,
please wait!
Loading...........
Figure 8-28 Typical screens seen during the firmware update