Vivax Metrotech FLS-2, Руководство пользователя

Страница: 40 / 58

™
Page 34 of 49
9 Operating the FLS-2 Transmitter
9.2.2 Main Screen Alarm Status
• When the current exceeds or falls below the preset limits, the display will show an
Alarm Screen.
Lines
Mode
Timer STANDBY
FLS-TX2W Main
8/10/2021
01:43 AM
w
SD512 + ELF-10
Status:
Health:
ACTIVE
OK
SD512: 03:56
ELF: 00:52
SD512: 70.5V
31.2V 499mA
31.2mA 50.0W
9.728W 100 Ohm
100 Ohm
ELF-10:
ALARM
LS Current to low
OK
Figure 9-2 Alarm on Main Screen
9.3 Operating Mode Menu
In this section, you learn how:
• To select a line
• To select a line frequency
• To set timer
• To set the line alarm levels
• To set the line output current level
NOTE
These instructions are written using the common abbreviated
method to move you from one screen to another. For example,
click Start > Control Panel > Printers.
9.3.1 Selecting Lines
From the Main screen, click Lines , and then select the lines needed if installed.
Figure 9-3 Examples of lines
Click OK to confirm and return to the Main Screen.
FLS-TX2W
Line Selection
8/10/2021
01:43 AM
OK Cancel
W.E
FLS
W E
FLS-TX4W
8/10/2021
01:43 AM
FLS
L1 L4 L2
L2,L4
L3
L1,L3
Line Selection
OK Cancel
FLS-TX16W
8/10/2021
01:43 AM
FLS
L16 L13 L14 L15
L8 L5 L6 L7
L12 L9 L10 L11
L4 L1 L2 L3
Line Selection
OK Cancel
2-Way 4-Way 16-Way
Figure 9-4 Select Lines
9.3.2 Selecting Modes (line frequency)
1. From the Main screen select Mode .
Mode
2. Use the scroll wheel to find the desired frequency.
W,E E W L3