Vivax Metrotech FLS-2, Руководство пользователя

Страница: 28 / 58

™
Page 22 of 49
7 First Time Installation and Setup
FLS-TX2W
Select Frequencies
to Install
8/10/2021
01:43 AM
Abort Next
ELF
SD512 SD640 LF512 LF640
982 8K 8440 9820
Figure 7-15 Select Frequencies to reinstall
2. Parameters for each installed frequency will be displayed as the new installation
is performed. At the end of the process the screen will automatically go back
to the Main Operating screen. You must complete this step to reinstall the new
frequency selection. You can also click the Abort button to abort the reinstallation
sequence at any time or click the Finish button to accept the new installation
when the button becomes enabled.
FLS-TX2W
Measuring Line
Impedances
8/10/2021
01:43 AM
Abort Finish
Step: 6/6 Dir: Line1 Sig: 4/4
56.1V
70.6V
70.5V
70.4V [1]ELF:
[2]SD512:
[3]LF512:
[4]8K: 562mA
499mA
706mA
708mA 32.0W
50.0W
50.0W
50.0W
Figure 7-16 Summary of the newly installed parameters
NOTE : All the other setup information is kept the same.
7.4 Reboot and Turn Off
Go to the
Main
screen and press the on/off icon on the top left side to reboot the
system. Then select
Reboot
and
Yes
to confirm the Reboot.
Also, use this menu when you want to power down the unit and press the
Yes
button
before flipping the on/off button to shut down correctly.
Figure 7-17 Reboot or turn off FLS System
7.5 Testing the Transmitter
After installing the transmitter, line protection, and control equipment, conduct the
following tests to ensure that the transmitter is operating properly:
• Check the modules’ LEDs for normal operation per section 5.5, “LED Status
Indicators.”
• Use a receiver to locate the energized line to ensure the signal transmits correctly.