Vivax Metrotech FLS-2, Руководство пользователя

Страница: 52 / 58

™
Page 46 of 49
14 Maintenance
14. Maintenance
This chapter contains the following sections:
• Calibration
• Removing or Installing Modules
• Cleaning
NOTE
Read the General Safety instructions before starting any
maintenance procedure.
14.1 Calibration
Only the Main Control module requires calibration. For information, contact technical
support.
14.2 Removing or Installing Modules
This section describes how to remove and install the transmitter modules.
CAUTION
These modules are sensitive to electrostatic discharge (ESD). Do
not touch the board components.
To remove a module
1. Turn the transmitter’s rear power switch off.
2. Use a Philips-head screwdriver to loosen the two side screws.
3. Open (unlock) the module’s ejector handles by pressing the red tabs and moving
the handles to the outside position.
4. Hold the handles and slowly pull out the module.
To install a module
1. Turn the transmitter’s rear power switch off.
2. Open (unlock) the module’s ejector handles by pressing the red tabs and then
moving the handles to the outside position.
3. Hold the handles and carefully place the module into the proper slot’s side guide
rails.
4. Slowly push the module into the slot opening until the faceplate is flush with the
classics.
5. Lock the handles by moving them to the inside position against the faceplate.
6. Use a Philips-head screwdriver to attach the two side screws.
14.3 Cleaning
Routine cleaning should not be necessary because of the installation environment.
However, turn the rear power switch off and use a slightly damp cloth if cleaning is
needed. Do not let water drip into the chassis or the hand-held display unit. Do not use
cleaning chemicals.