Vista SmartDisc 10IP, Руководство по установке

Страница: 37 / 74

4 Commissioning
36 Vista SmartDisc 10IP
the integrated motion detection in all instances.The device gives highest
priority to image recording triggered by input state change, i.e. when
Edge + or Edge – recording is active. If the device detects a status change
at any recording input, it will interrupt recording triggered by any different
status, by status change, or by integrated motion detection in any event.
■
For the device to positively detect control input states and status changes,
circuit time must be at least 0.5 seconds.
■
SmartDisc 10IP supports three operating modes. These are a compromise
between performance and functionality, at the same time leaving the
option to suppress certain functions, under certain circumstances.
SmartDisc 10IP factory setting is Duplex mode. Operating mode
overview:
■
Simplex = Live image transmission, or recording, or archive
evaluation
■
Duplex = Live image transmission and recording, or archive
evaluation
■
Triplex = Live image transmission and recording and archive
evaluation
■
For applications using several removable hard disks (for increasing storage
capacity or recording time) it is strongly advised to use uniformly
configured hard disks, to use these always in the same SmartDisc 10IP ,
and to provide them with unique labels. Also refer to chapter „Removable
hard disk“ (see “Removable hard disk” on page 29) .
■
SmartDisc 10IP is equipped with an integrated clock module with
calendar feature. Maximum deviation at an ambient operating
temperature of 40 °C is ±2.5 minutes per month. It is recommended to
synchronise the clock with PC time at regular intervals and to activate
automatic adjustment to summer/winter time.
■
During live transmission of images from analogue cameras,
SmartDisc 10IP inserts the date and time into the image top right,
conforming to ISO 8601. To distinguish different images stored at the
same time from each other, a consecutive image number is displayed after
date and time data, separated by a period or a space.
Above Firmware 1.82, a similar display can be parametrised as an option
on IP cameras as well.
■
On principle, always assign a Device name and assign unique Camera
names . This facilitates distinction, especially in large projects, not only for
live transmission but also for online and offline evaluation. In addition, you
can define camera groups and pool several cameras into logical groups.
■
Depending on equipment your SmartDisc 10IP supports connections to
several SmartControl stations. Simultaneous support is for up to 6 IP
connections, or 5 IP and 1 dial-up connection, or 4 IP and 2 dial-up
connections. The number of active SmartControl stations connected to
the same SmartDisc 10IP at the same time is displayed by the
SmartControl software below the video window. Simultaneous
connection to several SmartControl stations affects SmartDisc 10IP
performance.
■
You can enter up to four Telephone numbers / IP addresses that will be
processed in the event of an alarm, according to configurable criteria. Field
one has top priority. SmartDisc 10IP always dials these numbers
consecutively until one of the receivers is contacted. The number of