Vista SmartDisc 10IP, Руководство по установке

Страница: 34 / 74

4 Commissioning
Vista SmartDisc 10IP 33
4 Commissioning
This chapter describes the basic procedure for successfully commissioning
your SmartDisc 10IP and provides tips for configuration and design
strategies. The online manual for SmartControl and SmartControl PRO
software provides further information on configuration software and the
menus relevant to configuring your application. For clearness, the following
information refers to SmartControl software. SmartControl PRO software
provides identical features and can be used for commissioning as well
without any limitation .
4.1 First steps
1. Install SmartDisc 10IP as described in chapter "System description",
section "Mounting and setting up" and switch the device on (see
“Mounting and setting up” on page 12) .
2. Connect all input and output lines to your SmartDisc 10IP unit now, if
possible. All required plugs are included in the scope of delivery. Refer
to chapter "Pin assignment and functionality" (see “Pin assignment
and functionality” on page 19) .
3. To operate the IP cameras, SmartDisc 10IP offers you a dedicated
network interface, termed IP Camera . The factory settings are:
IP address = 192.1 68 .32.95 ; subnet mask = 255.255.255.0
If necessary, configure the IP cameras to operate on this network
before using with the SmartDisc 10IP .
4. Install the SmartControl software for operation, alarm verification,
and configuration from the installation CD. Please observe the
installation information in the online manual of the same name. This
manual is included in the installation CD.
5. Connect the SmartDisc 10IP to the PC with the SmartControl
software using a cable. Use either the optional Nullmodem cable, the
USB cable or the network cable. The last two cables listed are part of
the fixed scope of delivery for your SmartDisc 10IP .
6 . Start the SmartControl software and use option Connect to connect
to your SmartDisc 10IP unit, observing the following:
■
If you use the optional null modem cable: Open SmartControl
software in offline mode. Go to menu item Settings , menu item
Port A , menu item Mode . Activate option Null modem .
■ If using the USB connector cable, it may be necessary to install a
corresponding driver (refer to the sub-directory /Drivers in your
SmartControl or SmartControl PRO software).
In addition, you may need to activate the Transmitter index with
USB node option in the software (see Receiver options/Extras/
USB ).
■
If you use a network cable: Open SmartControl software in offline
mode. Go to menu item Settings , menu item Port A , menu item
Mode . Activate option TCP/IP . In addition, include your
SmartDisc 10IP unit as new transmitter in the transmitter list,
including the SmartDisc 10IP TCP/IP address. The factory settings