Vista SmartDisc 10IP, Руководство по установке

Страница: 38 / 74

4 Commissioning
Vista SmartDisc 10IP 37
repeats determines the maximum number of times the list will be
processed. In addition, the system can be configured to always dial all
numbers. The same telephone numbers will be used for routine calls and
for technical alarms. Alarm LED will remain active until the telephone
number list has been processed according to the set repeats.
■
Select option Alarm call in case of defective Hard Disk if you want to
send a hard disk error message to a SmartControl station. The connection
will be established approximately 45 seconds after the error occurs. If the
user confirms the alarm with Report again , another call will be made 6
minutes later. If the user clicks Do not report again , the transmitter will
call to report the hard disk error the next time the error is detected again
with device restart.
■ Select option Routine call every 24 hours , if you want to report
operability of your SmartDisc 10IP at regular intervals to a SmartControl
station. No images will be transmitted during this connection. The calls will
be logged in the log files of the transmitter and of the receiver.
■
SmartDisc 10IP checks all connected video signal inputs for video signal
failure (faulty camera, faulty video line, low contrast image, e.g. by covered
lens). Failure is reported for active cameras if the video signal has been
disturbed for about 10 seconds. The check interval follows the respective
recording interval. In the event of a faulty video signal, recheck takes place
after 3 seconds. Recording is resumed after error elimination. For non
recording video cameras failure will be reported after 60 seconds.
If you require additional features, please refer to the additional configuration
options in files
CAMTEL.INI
or
CAMCTRL.INI
. Refer to the respective
information in the
SmartControl
or
SmartControl PRO
software online
manuals.