Vista SmartDisc 10IP, Руководство по установке

Страница: 14 / 74

3 System description
Vista SmartDisc 10IP 13
■
The operating temperature for SmartDisc 10IP is between +5°C and
+40°C.
■
Provide sufficient ventilation. Do not block vents. Provide sufficient air
circulation for cupboard installations.
■
Never expose the device to direct sunlight. Keep it well away from other
sources of heat (radiators, etc.).
■
Installation orientation: vertical, horizontal, with a deviation of not more
than ±5°.
■
It is essential that you maintain the required ambient conditions for
outdoor installations. Protect the device against atmospheric influence.
■
Always switch SmartDisc 10IP off, using the main power switch, before
removing or inserting a hard disk.
■
Wait for at least 10 seconds after switching off the device before turning it
on again.
■
Always use the original power supply unit with the respective cable. Use it
only for the dedicated voltage. Ensure that the cable is intact. Never use
damaged cables.
■
Select an installation site protected against burglary and vandalism. Ensure
unrestricted ventilation.
■
Make sure that specification limits are not exceeded when connecting
external devices.
Electrical safety
■
Always make sure that your hands are completely dry before touching
SmartDisc 10IP , the power supply unit, cables, or sockets. Never touch
these with wet hands.
■
Disconnect the device from the power supply by pulling at the plug, not at
the cable. Never pull at the cable.
■
If water or any other liquid enters the device, immediately disconnect the
power supply. Have the device checked by customer service.
■
The device contains no components that can be adjusted or repaired by
the user. The device housing must never be opened ever.
■
Only authorised staff may open the housing for installing HYBRID Card 4 ,
PSTN Cards or ISDN Cards . The instructions in the included manuals
must be observed.