Vista SmartDisc 10IP, Руководство по установке

Страница: 65 / 74

8 Factory settings
64 Vista SmartDisc 10IP
Contact status Open :
Rec. method/trigger=Permanent; Recording interval (s)=1;
Number of images=1
Contact status Closing (Edge –) :
Rec. method/trigger=Off; Recording interval (s)=1; Number of images=10
General settings Part 2/3
Audio Listening=activated; Microphone=activated; Line=not activated;
Speaking=activated
Relay Relay 1 :
Name=Relay 1; Mode=Latch; Closed while idle=not activated;
Reset offline=activated; Closed=10 s
Relay 2 :
Name=Relay 2; Mode=Latch; Closed while idle=not activated;
Reset offline=activated; Closed=10 s
Serial channel Baud rate=9600; Mode=8N1 (8 data bits, no parity, 1 stop bit);
Function = Transparent
EMA (IDS = intrusion detection system)
EMA Enabled=not activated; Port=6666;
Synchronise device time with EMA=not activated
Message to be sent Address=00 00 00 (not defined);
For all following line entries:
Event=Off; Camera=1
Message to be
received
Address=00 00 00 (not defined);
For all following line entries:
Enabled=Off; Camera=1; Preset=Off; Alarm=Off; Relay=Off;
Trigger event=Off
Extras
Log file Last caller=not activated; Change of inputs=not activated;
Only when armed=not activated; Temperature=activated;
Video signal loss detection=not activated;
Service Alarm call in case off reboot=not activated;
Alarm call in case of defective Hard Disk=activated;
Routine call every 24 hours=not activated (Time=12:0);
Extra Use without hard disk drive=not activated;
Hang-up and redial on alarm=not activated;
Release access for PTZ, Relay, Audio after [] seconds = 60;
Software video signal lost detection = Immediately
Merge into images Merge camera names into images=not activated;
Merge transmitter name into images=not activated;
Only for IP cameras:
Merge date and time into images=not activated;
General settings Part 3/3
Upload / Download File name=not defined
Firmware-Update
(optional)
Update device with file=not activated
CI Adapter
(optional)
For all ALM50 Module control inputs: