Viper XPT 6000, Руководство пользователя

Страница: 38 / 67

32
5.3.3 Internal Maintenance
You may find it necessary to access the transport system of the Viper. If this is necessary you will need to
remove the Garage Door and Rear Access Panel.
To Remove Garage Door and Rear Access Panel
Take off the Garage Door and remove all 8 of the screws holding the Rear Panel on.
To Access the Transport System
Once the Garage Door and Rear Access Panel are removed you will see the platen assembly and the
access panel on the Viper deck. To gain entry to the Transport System you’ll need to remove the platen
assembly and take off the access panel.
Removing the Bellows
To access the transport system for cleaning you will need to remove the bellows.
1. The bellows are held in position with Velcro.
2. To remove the front bellow, carefully lift the tabs from the connection points on the shoe. Once
that is free, you can carefully separate the Velcro from the bellows where they attach on the front
of the machine. Remove the rear bellow in the same fashion.
3. Once removed, the bellows can be rinsed under warm water to rinse off the pretreatment buildup.
Cleaning the Rail System
Use a clean, lint free; damp cloth can be used to wipe down the rail system completely removing any
residue of pretreatment. Ensure that the rails are cleaned completely even in the crevices. Also, clean the
rail guides that the platen shoe plate rest on. Completely clean any residue of pretreatment from these
rails. After that, apply a light white lithium grease to the screw drive. DO NOT apply grease to the rails!
This is a greaseless system.
Re-Assemble the Viper
Re-assemble the machine in the reverse order that it was disassembled.