Viper XPT 6000, Руководство пользователя

Страница: 12 / 67

Viper XPT-6000
6
2.1 Uncrating
1.
Remove the Viper’s included metal stand and assemble (See Section 2 below) before removing
Viper from shipping crate.
2. Once stand is assembled, remove excess cardboard from around Viper and lift unit straight off
crate and onto stand.
CAUTION: The unit is heavy and requires at least two people to lift the Viper from the box
when placing it on the stand. Use proper lifting techniques.
3.
The Viper’s back will sit flush with the back of the stand, and the feet on the base will drop onto
the stand foot rests.
4. You can adjust the feet of the Viper by rotating the feet pads to either raise or lower the feet to
level the Viper as it sits on the metal stand.
2.2 Stand Assembly
Please see Appendix A, Stand Assembly, for stand assembly instructions.
2.3 Connecting the Pre-Treatment Fluid Lines
1. Find the 4 included tubes and 2 clear filters and unpack.
2. Insert one tube in each of the following ports on the back of the
machine by inserting the tube firmly into the connector. (Figure
2.3B)
3. One tube will connect to the Water IN quick connect.
Make sure that the tube labeled IN is inserted into this port.
Fig. 2.3 B – Firmly insert tube.
Figure 2.3-B