Viper XPT 6000, Руководство пользователя

Страница: 33 / 67

27
Items needed:

1 L Distilled water

Waste bucket or container
1.
Run the “Water In” hose to the distilled water. Run the “Water Out” hose to a waste bucket or
container.
2. Power on the Viper and select the Menu Screen (or press the F4 button).
3. From the Menu Screen, click the Fluid Maintenance button.
4. From the Fluid Maintenance screen, select the Clean button.
5. Follow all on-screen instructions
6. Discard wastewater after clean routine is complete
You also need to remove the absorbent Yellow Spray Suppressant Guards that lines the inside of the front
garage door and behind the spray bar. These yellow Spray Suppressant Guards collect over spray to help
keep your Viper cleaner and hold onto excess spray bounce. These are held in with Velcro.
5.2.2 - Cleaning the Viper Nozzle Tips:
After flushing the system with distilled water you will
want to use a very soft bristle toothbrush and clean the
nozzle tips using Image Armor CLEANING SOLUTION.
CLEANING THE NOZZLE TIPS IS NECESSARY TO
PREVENT ANY PRE-TREATMENT SOLUTION FROM
REMAINING ON THE NOZZLE TIPS AND DRYING OUT
CAUSING SPRAY PATTERN PROBLEMS. FAILURE TO DO THIS WILL RESULT IN NOZZLE TIPS THAT
MAY NOT BE ABLE TO BE CLEANED TO RETURN THE VIPER TO ITS ORIGINAL SPRAY PATTERN.
THE USER WILL THEN NEED TO PURCHASE A NEW TIP TO REPLACE NOZZLE TIPS THAT ARE THE
RESULT OF DRIED PRE-TREATMENT OR PRE-TREATMENT BUILDUP ON THE TIPS.
1. Take the toothbrush provided and some Image Armor CLEANING SOLUTION.
2. Starting with Nozzle Tip 1 unscrew the nut and take tip out of the machine.
3. Clean the tip with the wet tooth brush. Make sure to clean the entire tip thoroughly.
4. After cleaning Nozzle Tip 1, rinse the tooth brush off and re-wet.
5. Repeat Steps 2 and 3 until all the nozzle tips have been cleaned.